5 - 12 MC9190-G Integrator Guide
Figure 5-8
Bootloader Screen
8. Place the MC9190-G into a Single Slot Serial/USB Cradle.
9. Use the up and down scroll buttons to select Download from USB, then press ENTER.
10. The Bootloader displays the following:
Figure 5-9
Waiting for Input
11. On the WCE USBDownload application, locate the hex files to download.
Select required operation
Download from SD card
Download from USB
Exit
CAUTION To ensure a successful download, do not remove power from the MC9190-G while in Bootloader.
Waiting for input. . .
NOTE One hex file or multiple hex files can be selected. To select multiple files, press the Ctrl key while selecting
files.
If selecting multiple files to download, USBDownload reads the header of the file and identifies the file type. If
the Partition table file is among the files selected, then USBDownload downloads that file first. Similarly,
USBDownload downloads the CPLD file last.
To Next Page
Loading...
Need help?
General
