Motorola MTM800 - 13.3.5 TETRA Modes AT Commands; 13.3.6 Group Management AT Commands; 13.3.7 DMO AT Commands; 13.3.8 USB support

2-46 Services and Feature Description
6866537D87-F Chapter 2 - MTM800 Product Information Manual September 2008
13.3.5 TETRA Modes AT Commands
The terminal supports the following AT Command for support of TETRA Modes:
• TMO/DMO Operating mode (+CTOM)
13.3.6 Group Management AT Commands
The terminal supports the following AT Command for support of Group Management:
• Talkgroup selection (+CTGS)
13.3.7 DMO AT Commands
The terminal supports the following AT Command for support of DMO:
• Visible DMO Gateway or Repeater (+CTDGR)
13.3.8 USB support
The terminal supports flashing of the software, codeplug and encryption material via USB interface.
13.3.9 Network and Mobility Management AT Commands
The terminal supports the following AT Command for support of Network and Mobility Management:
• Network Registration (+CREG)
• TETRA Cell Broadcast Information (+CTBCT)
• Cell Signal Quality (+CSQ)
• Neighbour Cell Information (+GCLI)
• Radio User Assignment (+CTRUA)
13.3.10 Identity Management AT Commands
The terminal supports the following AT Command for support of Identity Management:
• MT Manufacturer Identification (+GMI)
• MT Revision (+GMR)
• MT Serial Number (+GSN)
• MT Hardware Model (+GMM)
• Fixed TETRA Identities (+CNUMF)
• Talkgroup List by Folder and DGNA Notification (+CTGL)
13.3.11 Service Profiles & Capabilities AT Commands
The terminal supports the following AT Command for support of Service Profiles & Capabilities:
• Service Profiles (+CTSP)
• MT Capabilities (+GCAP)
13.3.12 Call Control in TMO AT Commands
The terminal supports the following AT Command for support of Call Control in TMO:
• Defining Call Parameters (+CTSDC)
• Call Transmit Demand (+CTXD)