3-94 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
This has the following two options:
• Talkgroup
Using the mouse and clicking on a field will display a down arrow. Selected the arrow to
display all the available talk group entries in the Talkgroup list, again using the mouse click on
the required entry to add it to the scan list.
• Priority
This displays the talkgroup’s priority level. An ongoing call, with a low priority, will be
interrupted by a call from a high priority talkgroup. A call from a medium/low priority talkgroup
will not interrupt the on-going call. After entering the Talkgroup field value, check the Priority
field, select the now displayed down arrow to display the available groups and select the
required option.
The available options are:
• Low
• Medium
• High
24.1.4 Dynamic Group Number Assignment
This has the following two options:
24.1.4.1 DGNA Notification
If this option is enabled by selecting the check box, the user will be alerted when the terminal
receives an ‘Over the Air’ update to its talk group list.
24.1.4.2 Super Group of Scanned Groups Enabled
If enabled by checking the box, the terminal will scan the super group.
A super group has one GSSI, but is made up of several other groups. A call setup sequence
addressed to the super group will also set the call up to the other groups within the super group.
Super groups are setup by system dispatchers/administrators and are part of the DGNA feature.
See Chapter 2 of the Product Information Manual, Paragraph "Group Addressed DGNA" for more
information.
24.1.4.3 Auto Select Single Assigned Group
Indicates whether or not the terminal should automatically select a single assigned DGNA group.
Check the check box to Enable/Disable this option.
Using SS-DGNA, the SwMI may send a group assignment:
• to add a group or a number of groups to the terminal’s data base.
To Next Page
Loading...
