TalkGroups 3-91
September 2008
Chapter 3 - MTM800 Product Information Manual 6866537D87-F
24.1.1.3 Transmission Time Out Timer
The entry in this field is the per range allowed call talk time. The time range is from 0 to 300
seconds.
24.1.1.4 Transmission time Out Warning Timer
Parameter controlling, per range, the time for generating <TOT Warning Tone> prior to <TOT>
expires. The <TOT warning tone timer> shall be less than <TOT> setting.
The radio can continuously transmit until the <TOT Warning Tone timer> expired, then the phone will
generate <TOT Warning Tone> to alert the user that transmission will soon be stopped.
The time can be set between 0 - 299 seconds.
24.1.1.5 Number of Talkgroups in the Range
The parameter indicates the maximum number of Talkgroups that can be programmed in the folder/
range.
The number of talkgroups can be set between 0-1024.
24.1.1.6 Receive Only
This is a per range setting and if the check box is selected, the user will be able to hear the calls, but
will not able to set up group calls to any of the talkgroups in the range, or PTT during a call.
24.1.2 TMO Talkgroup List
Note: At least one entry field must remain empty if DGNA is to be used, see paragraph 12.1.5.
24.1.2.1 Name
This field can be programmed with up to 12 alphanumeric digits for the name/alias of the group.
Up to 16 entries can be added to each range, giving a total of 2048 group entries.
24.1.2.2 ID
This is a Group Short Subscriber Identity (GSSI) of up to 8 digits and in the range 0 to 15,999,999
can be entered in this field to define the identity of the group.
Note: The same group(s) can be added to several/all ranges as required.
To Next Page
Loading...
