3-50 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
14.37 Remote Programming
If enabled, allows programming a mobile terminal via a network without the need of bringing it
manually into programming mode.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.38 Call-Out
If enabled, allows Call-Out alerts to be sent and received.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
15 Security
15.1 MS Authentication
This feature may be required for several different reasons, see Chapter 2 Paragraph 9.2.
Checking the box enables/disables the MS Authentication Feature.
During normal operation the Switching and Management Infrastructure (SwMi) of the system may
require the terminal (mobile subscriber - MS) to authenticate, to allow access to the system
To Next Page
Loading...
