Motorola MTM800 - 16.14.8 Memory (if enabled in codeplug); 17 Tool Interface Support; 17.1 Software and Codeplug Flashing Tool Support; 17.2 Key Variable Loader (KVL)

Tool Interface Support 2-59
September 2008
Chapter 2 - MTM800 Product Information Manual 6866537D87-F
• List all SCKs stored in the MS, i.e. SCKN and SCK-VN attributes
•For GCK:
• Current Full GCK-VN
• List all GCKs stored in the MS, i.e. GCKN and GCK-VN attributes
16.14.8 Memory (if enabled in codeplug)
Contains the following options:
• Host Memory
• DSP P-Memory
• DSP X-Memory
• DSP Y-Memory
17 Tool Interface Support
The terminal supports interfaces with external diagnostic and testing software.
17.1 Software and Codeplug Flashing Tool Support
Equipment specific parameters, and other data that is required to be retained through power cycling
will be stored in non-volatile memory - known as the ’codeplug’. The terminal will support an
interface with an external tool (such as CPS) that is capable of reading from and writing to the
codeplug and flashing the terminal software via serial and USB interface.
17.2 Key Variable Loader (KVL)
The terminal supports provisioning of K, KEK and SCK via the KVL application. The terminal will
store the K in sealed format using TA51.