3-130 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
Zero, also used to identify the first cycle, was from the 6th January 1980 until the 22nd August 1999.
We are now in the 2nd period or cycle 1 and this runs until 2019.
The entry for this field is 1.
30.1.2 Leap Seconds
Specifies the difference between GPS time and UTC time. This parameter is used to synchronize
both time systems in the radio.
The range is 0 to 65.553 seconds, the default is 14 seconds.
30.1.3 Enable GPS via MMI
If this option is enabled, it is then possible for the user to enable/disable the GPS feature.
30.1.4 Test Page on the MMI Enable
Note: Not editable via Customer CPS.
30.1.5 Beep for GPS Coverage
This option enables/disables the terminal’s audio indications for GPS coverage.
30.1.6 Notification for GPS Coverage
Enable/disable the visual notification for loss of GPS coverage.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
30.1.7 GPS Authorised ISSI Base
This ISSI is the first in the range of valid ISSIs that the terminal will recognise when checking for
authorisation after receiving a location service request. The terminal checks the calling party ISSI.
30.1.8 GPS Authorised ISSI Range
The number entered in this Field Value defines the range of valid consecutive ISSIs from the GPS
Authorised ISSI Base.
30.1.9 GPS Coverage Poll Period
This option displays the time period in seconds after which the GPS coverage is checked and the
display icon updated accordingly.
The range for this setting is 0 - 2147483, the default is 180.
30.1.10 GPS Location Protocol
Selects the over-the air location protocol used for location requests and location reports.
There are 2 possible choices:
•LIP - Location Information Protocol (ETSI standard)
• LRRP - Location Request Response Protocol (non ETSI standard)
To select the option, put the pointer into the field value, click on the arrow, and drag the pointer to
the desired option.
To Next Page
Loading...
