EasyManua.ls Logo

Motorola MTM800 - 28.3.5 TXI (Transmit Inhibit)

Motorola MTM800
290 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-120 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
28.3.4.1 Private Call To
Place the pointer into the ‘Field Value’, click on the down arrow to display the Contact Book \ Private
Call List, place the pointer on the required option and select it by clicking the left mouse button. The
selected ISSI with its associated name and list position will now be entered into this field.
28.3.4.2 Private Call Type
Place the pointer into the ‘Field Value’, click on the down arrow to display the Simplex \ Duplex
option, place the pointer on the required option and select it by clicking the left mouse button. The
selected option will now be entered into this field.
28.3.5 TXI (Transmit Inhibit)
When this option is chosen, the following fields are enabled:
28.3.5.1 Activate
When TXI is enabled, the terminal can send a status message informing the dispatcher that it is in
TXI mode and is receive only. The status message number is manually entered into this field and is
not selectable from the Status List entries.
28.3.5.2 Deactivate
When TXI is disabled, the terminal can send a status message informing the dispatcher that it is in
now in normal operating mode. The status message number is manually entered into this field and
is not selectable from the Status List entries.
28.3.5.3 TXI Mode Started Timer
The entry in this field sets the time that the button must remain pressed before the TXI mode is
started.
The range is from 1 to 5000 msecs and the default is 500 msecs.
28.3.5.4 TXI Mode Cancel Timer
The entry in this field sets the time that the button must remain pressed before the TXI mode is
cancelled and the terminal reverts to normal operation.
The range is from 1000 to 5000 msecs and the default is 2000 msecs.
28.3.5.5 TXI Activation Timer
This is the time delay between TXI being selected and TXI actually starting, it allows time for all on
going procedures to be completed before transmission is actually blocked.
The range is from 1 to 30 seconds and the default is 15 seconds.

Table of Contents

Other manuals for Motorola MTM800

Related product manuals