Data Services 3-105
September 2008
Chapter 3 - MTM800 Product Information Manual 6866537D87-F
26.1 Outgoing Mail Parameters
Related field is: Paragraph 14.11 "Mail Out"
26.1.1 Outgoing Mail Options
26.1.1.1 Mail Received Tone in Active State
This feature is enabled/disabled by selecting the check box in this field and defines whether or not
the Mail Received (MLRCV) Tone In Active State feature is enabled. If enabled, the phone will emit a
single beep every time a mail message is received, even when the user is reading, writing, editing or
sending a mail message.
26.1.1.2 Predefined Template Protocol Identifier
Different protocol identifiers are available for the different message types and the entry in this field is
transmitted to the phone as part of the Predefined Template message. It enables the terminal to
identify the type of message, in this case as a Predefined Template message type 230 (this is also
the default). The Valid identifiers are in the ranges:
• 128 - 130
• 135 - 191
• 192 - 255
26.1.2 Outgoing Mail List
This list may contain up to 100 entries made up of the following options:
26.1.2.1 Template Type
This field allows you to select between UserDefined and PreDefined template types.
The PreDefined template is a message sent using the protocol identifier as set in the Codeplug ->
Data Services -> Outgoing Mail Parameters -> Outgoing Mail Options. It is not possible to send pre-
defined messages from phone display to phone display. This type of messages is intended for
database applications connected to the PEI of the receiving phone, or for a short data router on the
infrastructure.
To Next Page
Loading...
