Motorola MTM800 - 26.4.5 Status Min; 26.4.6 Send Short Form Report; 26.4.7 Access Priority; 26.4.8 AT Commands SDS-TL Access Priority

Data Services 3-111
September 2008
Chapter 3 - MTM800 Product Information Manual 6866537D87-F
The default is 61439.
26.4.5 Status Min
The TETRA standard defines the number range of status messages as 32768 to 61439.
The number entered in this field will be the lowest number that the terminal user can see and send.
The default is 32768.
26.4.6 Send Short Form Report
This Feature is a requirement for Nokia Systems.
When this feature is enabled, the terminal will automatically request an acknowledgement or send
an acknowledgement, whenever it sends or receives a status message.
26.4.7 Access Priority
This field is used to set the access priority of the SDS-TL reject report when no application is
registered to service.
Select the Field Value window to display the down arrow and the following available options:
• Low
•High
The default value is Low.
26.4.8 AT Commands SDS-TL Access Priority
This field is used to set the access priority for call set up using this data connection method.
When a computer is connected to a terminal and is being used as a ‘Hyper Terminal’, the user is
able to use the ‘AT’ command set for data communication.
Select the Field Value window to display the down arrow and the following available options:
• Low
•High
The default value is Low.
See Chapter 4 of the Product Information Manual.
26.4.9 AT Commands SDS-TL Traffic Stealing
It is possible, using AT Commands, to temporarily steal part of a traffic channels signalling capacity
to pass the message when this option is set to ‘High’.
26.4.10 Buffer Full, Overwrite Policy
As the terminal receives status messages, its buffer will eventually fill if messages are not deleted.
This feature has the following options:
• None - If this option is selected, the terminal will not buffer any more received status
messages once it is full.
• Overwrite Old + New - Selecting this option allows the terminal to overwrite any buffered
status message when the buffer is full.
• Overwrite only Old - Selecting this option allows the terminal to overwrite only the oldest
buffered status message, when the buffer is full.