TNP1 Support 3-115
September 2008
Chapter 3 - MTM800 Product Information Manual 6866537D87-F
27.1 Default Service Profile
This is a list of 256 read-only cells to store in each cell the Default Service Profile for each Protocol
Identifier (PI). The values of the cells are used only while the Point-to -Point (PPP) link is up (i.e.: AT
ON-line). The position of each cell within the list determines its PI. For example, PI for the first cell is
0 and for the last cell is 255.
Each cell has the structure of information element “SDS (Short Data Service) Control”.
The field values may be as follows:
• MT-controlled - only the application in MT will transmit requests or receive responses when it
controls the services.
• TE-controlled - only the application in TE will transmit requests or receive responses when it
controls the services.
• Neither
Values of some PIs cannot be changed, as they are reserved for the future use or restricted by
internal MT application.
27.2 Default Service Profile
This is a list of 256 read-only cells to store in each cell the User-Defined Service Profile for each PI.
The values of the cells are used only while the PPP link is up. The position of each cell within the list
determines its PI.
Each cell has the structure of information element “SDS (Short Data Service) Control”.
27.3 TNP1 Options
This menu is used to set the button/key functionality and it has the following options:
27.3.1 TNP1 Support
The TNP1 feature operates only when Packet Data or External Device is enabled in the codeplug
(i.e.: a PPP session with MT2 can be estabilished).
Turn the check box (Enable) or off (Disable) by clicking in the check box.
To Next Page
Loading...
