Motorola MTM800 - 13.3 AT Commands; 13.3.1 General AT Commands; 13.3.2 Packet Data AT Commands; 13.3.3 Status and Short Data Service in TMO & DMO AT Commands

PEI Characteristics 2-45
September 2008
Chapter 2 - MTM800 Product Information Manual 6866537D87-F
13.3 AT Commands
13.3.1 General AT Commands
The terminal supports the following general AT Commands:
• DTR Behavior (&D)
• Local Command Mode Echo (E)
• DTE-DCE character framing (+ICF)
• DTE-DCE data rate control (+IPR) (Baud Rate)
• Control flow control (+IFC)
• Restore Factory Default Configuration (&F)
• Restore Default Configuration (Z)
• Terminal Success Reply (OK)
• Terminal Error Reply (+CME_ERROR)
• Reboot the Terminal (R)
13.3.2 Packet Data AT Commands
The terminal supports the following AT Commands for support of Packet Data:
• DCD Behavior (&C)
• Setup a PPP link for Packet Data and/or TNP1 session (D)
• Select DTE-side stack (+WS45)
• Select WDS-side stack (+WS46)
13.3.3 Status and Short Data Service in TMO & DMO AT Commands
The terminal supports the following AT Command for support of Status and Short Data Service in
TMO & DMO:
• Defining SDS Parameters (+CTSDS)
• Sending SDS, Status, Alarm and layer2 acknowledgement (+CMGS)
• Receive SDS, Status and Alarm (+CTSDSR)
• PID registration/deregistration, Send SDS, Status, Alarm (+CMGS)
• Receive SDS, Status and Alarm(+CMT)
• Message mode (+CNMI)
• Supported SDS types (+CSDS)
Note: Depending on Codeplug setting "ETSI AT SDS/Status Format" defined in section 29.6.3, the
radio supports an ETSI compliant format or a Motorola Proprietary format. DMO SDS AT commands
are only supported in the Motorola Proprietary format.
13.3.4 TNP1 AT Commands
The terminal supports the following AT Commands for support of TNP1:
• Setup a PPP link for Packet Data and/or TNP1 session (D)
• Set the UDP/IP Link to Local Mode (+WS46=252)
• Set the UDP/IP Link to Wide Mode (+WS46=14)