3-6 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
3.2.4 Exit
Selecting this option will close the CPS. if a codeplug is displayed in the work box and has been
edited, the user is given three options about saving it.
3.3 Tools Menu - with no codeplug displayed
There is one sub-menu which is only visible with no codeplug displayed:
3.3.1 Enable Features
Whenever a feature paid flag is disabled, the CPS disables access to the fields belonging to
separately priced features.
Some TETRA features (MSPD for MTM800) are separately priced in terminals from release MR5.3
on, apart from MSPD from MR5.4 on. The customer who has paid either for a single feature or for a
number of features receives the Feature Enable kit, i.e. the Customer CPS and an USB dongle
("Feature Enable Dongle") that contains information about the total number of enables per feature.
To Next Page
Loading...
