3-48 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
14.25 Tx Audio Hi Pass Filter
The terminal has a High-pass Filter module for all microphone connections. When enabled, the
High-pass Filter module reduces the frequencies at the lower end of the frequency
This feature is used to ensure audio clarity in a noisy environment. (This filter is used for certain
terminal models. Please consult with your Service Provider.)
This is applicable in TMO and DMO.
Check box to enable this feature.
14.26 TNP1 Support
The TNP1 feature will operate only if Packet Data or External Device is enabled in the codeplug
(i.e.: a PPP session with MT2 can be established).
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.27 Selected Network Enabled
If enabled, the Selected Network Enabled option will be displayed on the terminal screen. The
option allows the terminal user to register to a network of choice from an allowed Network List.
Check box to enable this feature.
14.28 Address Book Restriction
When the Address Book Restriction feature is enabled, the user will be allowed to initiate a private/
phone/PABX call if a number stored in the list of received calls exists in the address book.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
14.29 TG Dialing by Index
The Talk Group (TG) Index feature can be entered via the keypad when only in either TMO or DMO
talk group mode, in idle or receiving but nor transmitting.
In this mode the terminal does not look at the Talk Groups per range, but as consecutive numbers
from the first talk group of range 1 to the last talk group in the last enabled range. i.e. 4 ranges of 16
talkgroups is equal to a list of 64 continuous talk groups, where a keypad entry of 17 equates to the
first talk group of range 2.
To enable this functionality, the required keypad presses are of a shorter duration than that required
when using the one touch button functionality.
Once the first digit has been entered a ‘Find’ soft menu appears and on completion of the talkgroup
digit entry, pressing the associated soft button will cause the talk group to be displayed. Once the
talk group is displayed, the user is then presented with the ‘Cancel’, ‘OK’ selectable soft button
options.
Selecting ‘OK’ will attach the terminal to the group, or pressing the PTT will attach the terminal to the
group and set up a call to that selected group.
The terminal will actively remain on the last selected talk group during the search process and calls
can be heard and answered via the PTT while the search screen is still displayed, thus allowing the
user to complete the talk group selection process.
Incorrect keypad entries are cleared using the ‘Clear’ option of a soft button.
To Next Page
Loading...
