3-72 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
19.2.2 DN314
The entry in this field is a number of transmissions of unacknowledged DM-SDS UDATA packet
data unit (PDU).
19.2.3 Pre-emption Timer
This is the maximum time to wait for pre-emption response (DM-PRE ACCEPT or DM-REJECT).
Type in the required value.
19.2.4 DMO Voice Priority over SDS
Determines if DMO Voice has more or equal priority compared to DMO SDS and Status.
The options are:
• Voice has more priority than SDS
• Voice has equal priority as SDS.
To select the option, put the pointer into the field value, click on the arrow, and drag the pointer to
the desired option.
19.3 DMO Gateway Timers
A DMO Gateway is equipment that can fulfill two rolls:
1. It acts as a repeater allowing calls between terminals from both the same and different sys-
tems.
2. It also enables system access to terminals in DMO.
A gateway may be installed at a site outside of a cell coverage area to provide extended coverage
for that cell in a particular direction.
This sub menu has the following options:
19.3.1 DT301
This entry defines the time that the terminal will wait for a response from a DMO Gateway to a DMO
Gateway set up (BM-GSETUP) request message before timing out.
The range for this timer is 0 - 30 seconds.
The default is 1second.
19.3.2 DT302
The entry in this field defines the time in seconds that the terminal will wait to be connected after
receiving a Gateway acknowledgement (DM-GACK) to a call set up request before timing out.
The range for this timer is 10 - 60 seconds. The default is 10 seconds.
To Next Page
Loading...
