GPS 3-133
September 2008
Chapter 3 - MTM800 Product Information Manual 6866537D87-F
SPEED_VERTICAL_WITH_ACC - Gives the magnitude of the vertical component of the velocity of
a target entity with accuracy.
SPEED_HORIZONTAL_AND_VERTICAL - Horizontal and vertical speed.
SPEED_HORIZONTAL_AND_VERTICAL_WITH_ACC - Horizontal & Vertical speed with accuracy.
30.3.6 GPS Unsolicited Uncertainty
This Filed Value is used to define the Horizontal (distance accuracy in metres) used for Unsolicited
Location reports.
It has a range from 0 to 100, the default is 100.
30.3.7 GPS Maximum Data Age
This entry defines the allowed maximum age, in seconds, of the data that will be sent for triggered
location report messages.
The range for this setting is 0 - 2147483 seconds, the default is 20 seconds.
30.3.8 GPS Max Acquisition Delay
This defines the time period that the terminal will wait (and the accuracy, if fix to required accuracy is
not obtained in the time - this also depends on available satellites), after entering this mode of GPS
operation, prior to sending an Unsolicited Location report. If a different report has been sent in this
time, it will us the information of that report.
The range for this setting is 0 - 2147483 seconds, the default is 45 seconds.
30.3.9 GPS Idle Report Period
The entry in this Field Value defines the time interval between successive checks of distance moved
by the terminal for this profile.
A distance based location report is only sent if the distance between the measurement and the last
reported position is higher than the distance threshold. The real moved distance could be higher i.e.
going back or going round the first point. Also the excursion may escape notice because the journey
time is within the time period between consecutive checks.
The range for this setting is 0 - 3600, the default is 300.
30.4 Emergency Periodic Profile
To Next Page
Loading...
