3-82 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
20.3.3 Channel Acquisition Timer
This is the period of time the phone waits before it advises the user it is out of service, not attached,
or is in local area service.
The range for this timer is 0 - 300 seconds, the default setting is 30 seconds.
20.4 Signal/Quality Indication Scale
These two fields are used for setting the number of bars that will be displayed to represent received
signal strength.
20.4.1 Signal Strength Max Nobars
TMO/DMO dependent.
This field defines the maximum number of bars that will be displayed to indicate the QUALITY of the
received signal in TMO, the bars are displayed to the left of the ‘mast’ icon and if the terminal looses
coverage a warning is displayed and an alert sounded.
This field also defines the number of bars that will be displayed to indicate the STRENGTH of the
received signal in DMO, the bars are displayed without the mast icon.
The range is from 0 - 127, the default being 9.
20.4.2 Signal Strength Min. Maxbars
This field defines the minimum number of bars that will be displayed to indicate the quality/strength
of the received signal. These bars are displayed to the right of the ‘mast’ received signal strength
icon.
The range is from 0 - 127, the default being 35.
This option defines the first call type that will appear on the idle display when the user starts dialing.
The call type is one of the following: Private/Phone/PABX.
21 Language Parameters
This menu has 2 options that set the language used for the terminal’s prompts, the first gives a
choice from the standard options and the remaining options allow user entry for the prompts.
To Next Page
Loading...
