GPS 3-131
September 2008
Chapter 3 - MTM800 Product Information Manual 6866537D87-F
30.2 LIP Configuration
30.2.1 Send Initialization Request
If enabled, the radio sends an Initialization Request after it is powered up and registered in the
network.
30.2.2 Destination ISSI
This is the destination Individual Short Subscriber Identity (ISSI) for Location Information Protocol
(LIP) reports. Usually this is the address of the LIP Location Server.
30.2.3 Min Reporting Interval
Note: The GPS Location Protocol must be set to LIP to make this field editable.
Duration in seconds which is not underrun between 2 successive LIP location reports.
The range is from 10 to 5280 seconds and the default is 10 seconds.
Related fields:
The GPS Profiles
30.2.4 LIP Max Data Age
Note: The GPS Location Protocol must be set to LIP to make this field editable.
Specifies the acceptable maximum age of location data in seconds.
The range is from 0 to 254 seconds and the default is 60 seconds.
Related fields:
The GPS Profiles
30.2.5 Max Respond Time
Note: The GPS Location Protocol must be set to LIP to make this field editable.
Specifies the maximum duration in seconds the GPS system has to acquire location data.
The range is from 0 to 3780 seconds and the default is 0 seconds.
Related fields:
The GPS Profiles
30.2.6 Delete All OTA LIP Location Report Requests
Removes all Over-the-Air (OTA) Location Information Protocol (LIP) report requests (triggered
requests) received over the air. This is clean up measure to delete orphaned requests that are no
longer useful.
To Next Page
Loading...
