2-54 Services and Feature Description
6866537D87-F Chapter 2 - MTM800 Product Information Manual September 2008
• English
• German
• French
• Spanish
• Dutch
• Swedish
• Russian (Cyrillic) (Standard Control Head only)
• User Defined Language *)
*) In addition to these languages, the terminal will provide an option to use a "Local Language"
where each text string used by the terminal is defined in the code plug
Benefits:
❏ Easy to train user speaking different languages to operate and understand the terminal and
menu
❏ Prevents user errors and irritations due to unknown languages of terminal messages
❏ Flexible: Can support any other language which is based on the character set mentioned
above
16.6 Scanning
The passive scan functionality has been replaced with active scanning. Whenever scanning is
enabled/disabled, a status message is sent.
Scanning of only the Group Area (cell to Cell) is supported.
16.7 Non Tactical Emergency to Emergency
This feature allows users to set up an emergency call to a designated talk group (a pre-defined talk
group). This feature is an alternative to the normal emergency group call operation where the call is
set up to the selected Tactical Emergency talk group.
The Tactical and Non-Tactical operational mode and Non-Tactical talk group GSSI are selectable via
the CPS during terminal programming.
The Hot Microphone feature operates normally, when enabled via the CPS.
Note: This feature is not supported on all systems.
16.8 DGNA Enhancement
DGNA now has scan functionality. The terminal also supports SwMI (system) intitiated attachment/
detachment to a group and SwMI initiated scan functionality during attachment/detachment to these
groups. This is a supported system feature that may not be available on all systems.
16.9 DGNA Auto Attach
DGNA enables a network operator or authorised user to dynamically (over the air) allocate talk
groups to selected terminals.
To Next Page
Loading...
