3-106 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
The UserDefined template is a text message enabling the user to save time required for typing a
message by using a pre-typed or saved messages.
26.1.2.2 Edit Type
This field defines the type of characters that can be edited in the Editable Text field and is only
enabled if PreDefined is selected in the Type field.
Three options available are:
• Numeric – enables writing of numeric characters only (0 to 9).
• Alphanumeric – enables writing of all available alphanumeric characters.
• Mixed – enables writing of the following characters only: 0 – 9, *, #.
To choose the characters type, put the pointer inside the field, click on the arrow, and drag the
pointer to desired selection.
Note: When selecting the pre-defined text via the menu option, characters can only be deleted.
If User Defined is selected in the Type field, alphanumeric is the default and cannot be changed.
26.1.2.3 Prompt ID
This is a reference number, allowing multiple messages to be sent to the same address. The remote
application works out what to do with each message as it is received (i.e. route it to some other
destination). The field is enabled only if PreDefined is selected in the Type field.
26.1.2.4 Prompt Text
This field contains non-editable prompt text of up to 12 characters that will appear on the phone
screen, e.g. “Arrived At”, the user is then able to add further text to the message. The field is
enabled when PreDefined is the selected option in the Type field.
26.1.2.5 Editable Text
This field contains the actual text message (PreDefined or User Defined) and is editable. Edit
capability as a PreDefined message is limited to deleting characters. Maximum message size is up
to 124 characters for a PreDefined message (according to the Edit Type field selection) and up to
140 alphanumeric characters for User Defined message.
Note: Messages can be created by user action via the menu message option and as well as any
received message, they can be stored in this list as a template by selecting the ‘Add to Template’
option while in message mode.
26.1.2.6 Address
This field is only enabled by selecting the ‘PreDefined’ option in the Type field and it contains the
address to which the message will be sent, usually to an ISSI.
26.1.2.7 Edit Size
This field defines how much of the text message is editable. If User Defined is selected in the Type
field, the Edit Size field content is calculated according to actual message size + 1 up to a maximum
of 140 characters. When PreDefined is selected in the Type field, the Edit Size value must be
entered manually (up to 124 characters) before writing in the Editable Text field.
To Next Page
Loading...
