Motorola MTM800 - Page 206

3-92 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
24.1.2.3 Status
Select a box to display the down arrow and choose from the available options. An entry can be
enabled by selecting the ‘Programmed’ option, disabled and not seen by the user when the ‘Not
Programmed option’ is selected, or if the ‘Invisible’ option is selected it will not be seen or be
selectable by the user, but it can be added to a scan list via CPS programming.
24.1.2.4 Folders List
This field is an automatically filled read-only list. It lists the number of talkgroups in the range (done
in TMO Folders List page).
24.1.2.5 Announce Group
An announcement call (also called multi-group call) is a special case of group call. It provides the
capability for the dispatcher or the phone to communicate with more than one talkgroup at the same
time.
Select the check box to enable this option
24.1.2.6 Start Announce Call
Select the check box to make an entry active. If an entry is not checked, the user is not allowed to
initiate an announce call.
24.1.2.7 Associated Announce Group
If the talkgroup is not an ATG (announce talkgroup), this field indicates to which ATG the talkgroup
is assigned.
24.1.2.8 Group Priority
The entry in this field determines the scanning priority of the talkgroup. If landed on a group, the
terminal will discard this group call if, during background scanning, it lands on group with a higher
priority. The four available options are:
• Low
• Medium
• High
• Always Scanned
24.1.2.9 GCK Number
Stores the association between a TMO talkgroup and a GCK. This parameter is repeated for every
TMO talkgroup entry in the codeplug. The range is from 0-65536.
Type in the required value.
24.1.2.10 DMO Mapping
The mapped DMO talkgroup is selectable and derived from the Talkgroup list.
You can associate a DMO talkgroup configuration to a TMO talkgroup configuration. This means
that if you are on TMO talkgroup 3, for example, then you are not bound to use DMO talkgroup 3
should the user switch to DMO. In your DMO fleetmap, it’s possible to associate any TMO talkgroup
to ANY DMO talkgroup, so in this example you could make DMO talkgroup number 23 the relevant
DMO talkgroup for TMO talkgroup number 3.