Address vario.
Sensor address of the variometer.
Address altitude
Sensor address of the altitude sensor.
Interval
OFF: The altitude is announced "by grid". The grid adjusts to the
altitude: Up to an altitude of 100m the grid spacing is 25m, up to 300m
it is 50m, and above it is 100m.
4 30s: The altitude is announced at the set intervals.
The altitude announcement can be configured as switchable in the Setup >
Assign.Switches by assigning a switch.
4.3.5.2 Announce & Alert
Vibration
Activates/deactivates device vibration to report sensor alarms.
Announcements
Speech output can be generated for the sensor values. This option can be
activated for each sensor individually. Please note that the announcement for
a single sensor takes several seconds. For 16 sensors, the complete
announcement sequence can take up to one minute. For this reason,
announcements should only be activated for important sensors.
Sensors that trigger alarms are always announced even if they are not
activated.
Break
The break interval between two announcement sequences can be set to a
value between 30s and 180s.
Sensor 0 to sensor 15
Here, you activate the announcement for each sensor individually.
To Next Page
Loading...
