Multiplex Profi TX - V2 Software; Update from V1 to V2; New Features in V2; Speech Output

Introduction
PROFI TX
Page 9
PROFI TX 9
PROFI TX 12
PROFI TX 16
Channels
9
12
16
Model memories
50
100
200
Other
Volume control using
mixers
1.2 V2 software
1.2.1 Update from V1 to V2
Additional files must be installed when updating from software version 1 to
version 2. Refer to section 6.3 "Software update" on page 178 for details.
In version 2.xx, the volume settings are stored in the model memory. The volume is
set to 16 by default for newly created model memories. This setting is not available
in older model memories: The volume is initially set to OFF. You can configure the
desired volume level in the Setup > Volume menu.
1.2.2 New features in V2
1.2.2.1 Speech output
The following information can be output as speech:
 remaining operating time (time to empty; in minutes) for the transmitter
 flight phase
 status of the teacher / student connection
 trim position
 time markers of the timers
 announcement of the altitude
 announcement of selected sensor channels
 sensor value when a sensor alarm is issued
 announcement of the time of day by the alarm clock
Sound and speech output can be customised. Details will be made available in the
Downloads section of our home page by the 3rd quarter 2014.