Multiplex Profi TX - Intended Use

Introduction
PROFI TX
Page 17
1.8 Intended use
The PROFI TX transmitter is intended exclusively for operation of models by
radio control.
Always follow the switching on/off sequence in order to avoid any uncontrolled,
dangerous startup of the power system:
Switching on sequence using the BEC:
1. Disconnect the BEC connector from the receiver.
2. Set the throttle on the transmitter to OFF, then switch on the
transmitter.
3. Connect the power system battery.
4. Connect the BEC connector to the receiver.
Switching off sequence using the BEC:
1. Disconnect the power system battery.
Switching on sequence using the receiver battery:
1. Disconnect the power system battery.
2. Set the throttle on the transmitter to OFF, then switch on the
transmitter.
3. Connect the receiver battery.
4. Connect the power system battery.
Switching off sequence using the receiver battery:
1. Disconnect the power system battery.
2. Disconnect the receiver battery.