4.3.7.3 Switch
The following parameters in the menu indicate the switchable functions provided in
the software. Refer to section 5.4.2 "Assign.Switches" on page 173 for the list of
functions.
To assign a control function proceed as follows:
1. Open the desired input field.
2. Assign the desired switch by operating it. Other MagicSwitches (MS1.. MS4)
and the flight phases (FP1.. FP4) cannot be assigned by operating them. The
wheel must be used to do so.
3. Set the switch to the ON position or select it using the REV/CLR button.
4. Close the input field.
To Next Page
Loading...
