Multiplex Profi TX - Controlfunctions Main Menu

The menus
Page 118
PROFI TX
4.4 ControlFunctions main menu
You can use this menu to adjust the settings for control functions, e.g. trims,
travels, control curves, etc.
The menu is dynamic:
 It lists only the control functions that are actually used, i.e. the control
function must control at least one servo directly using mixers.
 The menu content differs for vehicle models, fixed-wing models, and
helicopter models.
 Control functions that do not have configurable parameters are not shown
(Wheel Brake, Mixture, Towing dog).
Refer to section "Control functions of the model templates" on page 172 for a list of
the control functions offered by the PROFI TX model templates.
Overview of controls functions - fixed-wing models
Aileron
Trim Step size, Expo
FP
, D/R, Travel
FP
Elevator
Rudder
Throttle
Trim: Step size & Mode, Expo, Run-up Time
Flap
Slow, Fixed value
FP
Spoiler
Retract.Gear
Aux-1
Aux-2
Aux-3
Aux-4
Gyro
Type of Gyro, Fixval. Sense
FP
, Suppression, controlled Axis
FP
= with flight phase switching