4.5.2.3 Control mixers (Ctrl.Mix)
These "mixers on the control side" mix the signal of any second (Source)
control function into any (Target) control function. Mixing takes effect on all
servos that are connected to the target control function either directly or via mixer.
These mixers are typically used for throttle compensation in helicopters. In the
helicopter templates, 4 of these mixers are provided.
Refer to page 134 for a detailed description of the Ctrl.Mix mixers.
4.5.2.4 Mixers on the servo side
"Mixers on the servo side" are mixers that combine up to 8 control functions in one
common signal. Their output signal can be assigned to one or more servos. The
mixers are defined in the Setup > Define mixer menu (see section 4.3.8
"Define mixer" on page 110).
If they are assigned to a servo, these mixers can be configured in the Mixer menu
according to the requirements of the particular model.
Refer to page for instructions on how to configure mixers136 on the servo side.
To Next Page
Loading...
