3.1.1 BASIC model template
This model template is designed for simple power or glider-type models and
for models without aileron.
This model template should also be used for model flying simulators.
Servo assignment
If you install a second aileron servo to provide separate linkage for the ailerons,
simply assign the Aileron function to a free servo (see "Assign" starting from
page 149). Would you like to raise the ailerons as an airbrake? In that case, assign
the AILERONS+ mixer to both aileron servos at the same position. The extended
airbrake will cause major load distribution changes: Change the elevator to
ELEVATOR+. It is then possible to compensate for the effects of Throttle and
Spoiler (airbrake).
Pre-defined mixers on the control side, with 2 more that can be defined by
the operator.
To Next Page
Loading...
