List of control functions to which controls can be assigned as desired. The
control functions "Aileron", "Rudder", and "Elevator" are not included in this list
as they are assigned to the sticks using the controls mode.
o Refer to section "Control functions of the model templates" on
page 172 for a list of the control functions.
o The freely assignable controls are listed on page 171.
To assign a control function proceed as follows:
o Open the desired input field.
o Assign a control by pressing the + / – buttons, by using the central
wheel or by operating the control.
o To set the actuation direction keep the control in the desired zero
position and close the input field. Alternatively, you can invert or
erase the input by pressing the REV/CLR button, if required.
To Next Page
Loading...
