Editing the model name
The new model that is created has the same name as the template used:
HELIccpm. For easier reference, you should change the name to the actual model
name:
7. Open the Memory > Edit name menu.
8. Enter a name (max. 16 characters) that clearly identifies the model. Refer to
page 161 for details.
The creation of a new model in the memory is now completed. These settings
determine the following in the model memory:
Receiver output assignment
o Servo 1 to 6 are pre-defined
o The servo assignments can be changed and amended as required
(Servo > Assign menu).
Controls assignment from the template
Controls are assigned to control functions in the Setup > Assign.Controls
menu:
To Next Page
Loading...
