EasyManua.ls Logo

Multiplex Profi TX - Page 223

Multiplex Profi TX
227 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix
Seite 220
PROFI TX
develops. The teacher transmitter carries out all the data processing. This
means that the student transmitter (depending on the type used) simply
needs to be switched to "Student" mode. No further configuration or
programming is required. All the teacher transmitter needs from the student
transmitter are the pure stick signals.
Trimming
Adjustment of the model aircraft to fly straight and level when you leave the
sticks exactly at centre.
Standard trim
Shifts the entire setting range of the stick in parallel up and down (by the trim
value). To allow this shift without limiting the control signal, the control signal
must be reduced by the maximum trim value possible. Thus, unlike centre
trim, the servo travel cannot be fully used.
Variometer
Device in the model aircraft that indicates the climbing and descending rate
through audible signals.

Table of Contents

Other manuals for Multiplex Profi TX

Related product manuals