For "spread spectrum", every data bit is coded in 64 bits (spread). This procedure
provides a high level of immunity to interference. During binding, the transmitter
passes "hopping sequence“, "spreading code", and "response time" to the receiver.
Procedure
The binding procedure can be started in 2 ways: via the keypad during startup or
via the menu.
Starting the binding procedure when the device is switched on:
1. Press and hold the ¡ button for the full duration of the transmitter startup
procedure.
o The annular ring of the Power button is flashing in orange and the flashing
message "BINDING" is shown in the status displays #2 to #8.
2. Now, switch on the receiver while pressing and holding the Set button (connect
the power supply).
o The receiver LED is flashing rapidly.
3. The binding procedure is completed within a few seconds:
o The annular light returns to flashing yellow.
o The receiver LED is flashing slowly.
o The servos that are connected to the receiver can now be controlled.
Starting the binding procedure via the menu
1. Switch off the receiver and switch on the transmitter.
o Press the ¡ button to open the "Setup" menu.
o Use the wheel to select the "M-LINK" menu item. Press the wheel.
o Open the "Binding" menu item. Press the wheel . The input field OFF is
now highlighted.
o Turn the wheel to the right: The text "seeking.." is now displayed in the
input field and the annular light of the Power button is flashing in orange.
The transmitter is searching for a receiver in binding mode.
o You can cancel the binding procedure at any time: Turn the wheel to the
left. The previous condition is restored.
2. Now, switch on the receiver while pressing and holding the Set button (connect
the power supply).
o The receiver LED is flashing rapidly.
3. The binding procedure is completed within a few seconds:
To Next Page
Loading...
