Multiplex Profi TX - Page 92

The menus
PROFI TX
Page 89
4
Current time. An asterisk next to the time indicates that the alarm clock
function is activated.
The following warnings are displayed in capital letters.
MEMORY ERROR!
Displayed when errors occur while loading a
model memory. (page 163)
RANGE!
Transmitting power is reduced for the range
check. (page 95)
RF ERROR!
The RF component is defective.
STUDENT MODE!
The Student mode is enabled.
STUDENT
Only in Teacher mode: The selected control
functions are transferred to the student.
MULTIFLIGHT
A MULTIFlight stick was detected: The mixers
on the servo side are switched off.
5
Sensor display on status display #2
Displays the values for sensors 0, 1, and 15 if a receiver with downlink
is used. The value is shown crossed out if no sensor signal is received
for several seconds.
If the sensor reports an alarm:
 The sensor value starts to flash.
 The appropriate warning light for the sensor group below the screen
starts to flash (see section 2.1.1 " Top view" on page 23).
 The device also starts to vibrate if the vibration alarm is activated
(see section 4.3.5.2 "Announce & Alert" on page 103).
If the sensor clears the alarm the value stops flashing. The vibration alarm
and warning light remain active until they are cleared by pressing the
ENTER button.
Notice: In other status displays the ENTER button has different
functions.