Element Action
Knob: Click the knob and drag your mouse vertically to change
the parameter value. Hold [Shift] on your computer keyboard and
drag your mouse to adjust the value in finer increments.
Button: Click the button to switch its state. When the button is
enabled, it shows a small colored LED.
Selector: Click the displayed value to open the drop-down list,
and click another value in the list to select it.
Navigating Channel Properties, Plug-ins, and Parameter Pages using the Controller
On the MASCHINE STUDIO controller, do the following:
1. Set the focus on the desired Sound, Group or the Master (see section ↑2.3.1, Setting the
Focus on a Group or a Sound).
Basic Concepts
Common Operations
MASCHINE STUDIO - Manual - 48
To Next Page
Loading...
