â–ª The Sample can be played back at any time by pressing the corresponding pad on your
controller. When the Sample is played back, the playhead indicator (vertical line) shows
you the current play position within the waveform on the right display.
The parameters available at the bottom of the left display are spread over two pages.
â–º
Use the Page buttons on the left of the displays to select the desired page.
Page 1 – PLAY RANGE Parameters
The parameters in the PLAY RANGE section allow you to adjust the range that will be played
back when you trigger a note.
The EDIT page on the controller, page 1 of 2: adjusting the play range of the Sample.
Parameter Description
START (Knob 1) Adjusts the start point of the play range in the Sample.
END (Knob 2) Adjusts the end point of the play range in the Sample.
Hold SHIFT when turning the Knobs to adjust the parameters in finer increments.
In the waveform on the right display, the regions outside the play range are grayed out.
Sampling and Sample Mapping
Editing a Sample
MASCHINE STUDIO - Manual - 829
To Next Page
Loading...
Need help?
General
