Letter Quality Document Statement Printer
How to Replenish the Statement Printer Paper
NCR Personas M Series 5887 Operator Manual 6-7
Type 2
6
To replace printer paper, proceed as follows:
1 Open the exterior of your ATM.
2 If your ATM does not have the auto-supervisor option, press the
switch on the operator panel to the supervisor position.
3 Access the statement printer as described in Chapter 1, ‘Getting
Started’.
4 If there is still some paper left in the printer, push the paper feed
switch on the top of the printer as shown below, to unload the
paper. When the paper stops moving, pull the end of the paper
out of the printer.
Note: If the feed button does not function, it could be because
there is a fault condition that has not been cleared. Clearing the
condition(s) should allow the paper to be unloaded.
To Next Page
Loading...
