Cash Acceptor
Cleaning Sensors
NCR Personas M Series 5887 Operator Manual 11-25
Recognition Unit (Area
Three)
11
To clean the sensors in this area of the recognition unit, proceed as
follows:
1 Open the vertical feed transport. Lift up the green pin-latch and
pull down the transport.
2 Using the compressed air and tube attachment, insert the tube
approximately 10 cm (4 in.) into the areas shown below.
3 Apply compressed air to the four sensor lenses under the top
bracket.
1
2
Clean four lenses
under the top bracket
Clean four prism ends
on lower bracket
To Next Page
Loading...
