Cheque Acceptor
Removing and Replacing the Ribbon Cassette
12-18 NCR Personas M Series 5887 Operator Manual
Multiple Line Endorser
12
1 Open the exterior of the terminal.
2 If your terminal does not have the auto-supervisor option, press
the switch on the operator panel to the supervisor position.
3 Access the module as described in ‘Getting Started’.
4 Pull down the green latch and pull out the endorser unit.
5 Pull out the green plastic latch to release the ribbon cassette.
6 Remove and discard the used ribbon cassette.
7 Remove the packaging from the new ribbon cassette including a
red tab or clip if there is one
8 Insert the new ribbon cassette by pushing in to the endorser unit
until the green plastic latch clicks and holds the cassette in
position. Ensure ribbon is around the print head.
9 Make sure the ribbon feeds through the guides correctly and
does not feed along the outside edge of the guides.
2
Ribbon
Cassette
1
Ribbon Feed
Knob
To Next Page
Loading...
