Cheque Acceptor
Removing and Replacing the Ribbon Cassette
NCR Personas M Series 5887 Operator Manual 12-19
10 Check that the new cassette has been replaced correctly by
turning the ribbon feed knob on the right side of the cassette.
This action will also tighten the ribbon.
11 Push in the multiple line endorser unit until the latch clicks and
locks into position.
12 To close, firmly push in the module until the latch clicks and
locks into position.
13 Follow your in-house procedures to indicate that the ribbon
cassette has been replaced.
14 If your terminal does not have the auto-supervisor option, press
the switch on the operator panel to the normal position.
15 Close and lock your terminal.
To Next Page
Loading...
