Getting Started
How to Insert and Remove Disks
1-34 NCR Personas M Series 5887 Operator Manual
How to Insert and Remove Disks
1
The procedure for inserting and removing disks depends on the
type of PC core in the ATM. There are two types of PC core. The
difference between them is shown below:
The following procedures are detailed below:
● Inserting and removing a flex disk in a Type 1 core
● Inserting and removing a CD-ROM in a Type 1 core
● Inserting and removing a flex disk in a Type 2 core
● Inserting and removing a CD or DVD-ROM in a Type 2 core.
Flex Disk in a Type 1 Core
1
To insert and remove a flex disk from the drive in a Type 1 core
proceed as follows:
1 Open the top-box of your ATM.
2 If a disk drive security cover is fitted, unlock or remove the lock
or seal supplied by your organization, then pull out the popper
and pull out the cover as far as it will go.
Note: If your ATM has an enhanced alarm system fitted, the
disk drive security cover may be alarmed. If this is the case, you
Type 1 Core
Type 2 Core
To Next Page
Loading...
