Cheque Acceptor
Emptying the Cheque Bins
12-4 NCR Personas M Series 5887 Operator Manual
Power Pockets
12
To remove cheque(s) from the capture bin or cheque receiving bins
in the power pocket variant, proceed as follows:
1 Open the exterior of the terminal.
2 If your terminal does not have the auto-supervisor option, press
the switch on the operator panel to the supervisor position.
3 Access the module as described in ‘Getting Started’. Proceed to
Step 5. If you have a cheque acceptor with a racking bin module,
proceed to Step 4.
4 Racking Bin Module (front access view shown
):
To access the areas in the bin module only, push down the bin
module latch as shown below, and pull out the entire bin
module until the slides are fully extended.
Latch
Bin Module
1
2
To Next Page
Loading...
