Letter Quality Document Statement Printer
How to Replenish the Statement Printer Paper
NCR Personas M Series 5887 Operator Manual 6-3
How to Replenish the Statement
Printer Paper
6
Type 1
6
To replace printer paper, proceed as follows:
1 Open the exterior of your ATM.
2 If your ATM does not have the auto-supervisor option, press the
switch on the operator panel to the supervisor position.
3 Access the statement printer as described in Chapter 1, ‘Getting
Started’.
4 If there is still some paper left in the printer, push down the
paper feed switch on the top of the printer as shown below, to
unload the paper. When the paper stops moving, pull the end of
the paper out of the printer.
Note: If the feed button does not function, it could be because
there is a fault condition that has not been cleared. Clearing the
condition(s) should allow the paper to be unloaded.
To Next Page
Loading...
