NCR 5887 - How to Unlock and Lock a Controlled Access Electronic Lock; Unlocking the Master Lock

Getting Started
How to Unlock and Lock a Controlled Access Electronic Lock
NCR Personas M Series 5887 Operator Manual 1-21
How to Unlock and Lock a
Controlled Access Electronic Lock
1
Note: For ATMs with security enclosures fitted with a Kaba Mas
(Mas-Hamilton) controlled access electronic lock, refer to the
following Kaba Mas Corporation publications for details of how to
set up and manage the operations of the lock:
● CENCON System 2000 Access Control System
● Getting Started Guide
● Supervisor Guide
● Special Supervisor Guide
● FLM Dispatcher Guide
● Route Dispatcher Guide
● CENCON 2000 System Guide.
These publications can be purchased from the following order
point:
Kaba Mas Corporation
749, W.Short Street
LEXINGTON, Kentucky
40508
Tel: (1) 859 253 4744
Toll Free: (1) 888 959 4715
Fax: (1) 859 225 2655
Note: For the attention of Customer Service Manager.
The controlled access electronic lock, called the master lock, can be
fitted with or without a sub-lock on the Cheque Acceptor door. To
unlock a security enclosure with a master lock and one sub-lock,
you will require the following:
● Personal Identifier key (PI key)
● 6-digit access code - obtained from the Key Management Centre
(KMC).
Unlocking the Master Lock
1
To open the master lock, proceed as follows:
1 Contact the KMC.
2 Give requested details to verify your identity to the KMC.
3 Specify which areas on the ATM you want to access.