Getting Started
How to Insert and Remove Disks
1-38 NCR Personas M Series 5887 Operator Manual
4 Place the CD-ROM in the tray with the printed label visible and
the machine readable surface next to the tray. Press the eject
button to retract the tray into the drive.
5 To remove a CD-ROM from the drive, press the eject button on
the drive to bring out the motorized tray. Remove the CD-ROM
from the tray and press the eject button to retract the tray into
the drive.
6 If fitted, close the disk drive security cover then lock or seal it as
required by your organization.
7 Close and lock the ATM.
Flex Disk in a Type 2 Core
1
To insert and remove a flex disk from the drive in a Type 2 core
proceed as follows:
1 Open the top-box of the ATM.
2 If a disk drive security latch is fitted, unlock or remove the lock
or seal supplied by your organization, then pull out the popper
and pull out the latch as far as it will go.
Note: If your ATM has an enhanced alarm system fitted, the
disk drive security latch may be alarmed. If this is the case, you
To Next Page
Loading...
