Getting Started
How to Switch Your ATM Power On and Off
1-6 NCR Personas M Series 5887 Operator Manual
How to Switch Your ATM Power On
and Off
1
To switch the mains power to your ATM on or off, proceed as
follows:
1 Open the top-box of your ATM.
2 Shut down the ATM as described in your in-house procedures.
3 Press the switch to the required ON (pressed in at the"1" side) or
OFF (pressed in at the "0" side) position.
Note: After you have switched your ATM power on, it will
take several minutes for the ATM to load all its software and
start displaying your application.
Do not attempt to load paper into the printers until the ATM has
completed its power up procedures and started displaying
either your application or the supervisor menu.
4 Close your ATM.
0
To Next Page
Loading...
