Getting Started
How to Unlock and Lock a Standard Security Enclosure
NCR Personas M Series 5887 Operator Manual 1-15
5 Turn the dial clockwise until the bolt retracts. The lock is now
open. Use the handle on the door to retract the door bolt and
open the door.
How To Operate The Silent Alarm
1
The silent alarm is triggered, if fitted, by adding 10 to the first
number of the combination. For example if the first number was 34,
dial 44 to trigger the silent alarm. Dial the next two numbers of the
combination as normal, the combination lock will open as normal
but the alarm will have been triggered.
How To Lock The Combination Lock
1
To lock the combination lock, turn the dial at least four complete
turns counterclockwise. If a keylock is fitted to the combination
lock, turn the dial until 0 is in line with the opening index and then
turn the key counterclockwise and remove it from the lock.
How To Change The Combination
1
Detailed instructions on how to change the combination of a lock
are inside the security enclosure.
Combination Lock and
Separate Keylock
1
Unlocking
1
On arrival at the site, the combination lock is set at the original
factory setting of 50. To unlock the security enclosure, proceed as
follows:
1 Turn the dial of the combination lock until 0 is under the index
mark.
2 Turn the dial of the combination lock counterclockwise until 50
is under the index mark for the FOURTH time.
Note: Combination locks are precision locks, therefore, extreme
care must be taken to align combination numbers with the index.
Turn the dial slowly and steadily. If any of the numbers in the
combination is turned beyond the index, the entire series of
numbers must be re-dialled.
Index Mark
To Next Page
Loading...
