NCR 5887 - Page 32

Getting Started
How to Unlock and Lock a Standard Security Enclosure
1-14 NCR Personas M Series 5887 Operator Manual
The procedures for unlocking and changing the combination on a
combination lock are the same regardless of whether the lock is a
primary or secondary lock.
Factory Setting
1
If the combination lock is set at the original factory setting of 50, you
unlock it as follows, dialling on the opening index:
1 If a keylock is fitted to the combination lock, insert the key into
the lock and turn it clockwise.
2 Turn the dial a minimum of four turns counterclockwise and
stop on 50.
3 Turn the dial slowly clockwise until the bolt retracts. The lock is
now open. Use the handle on the door to retract the door bolt
and open the door.
Customer Setting Combination
1
If the combination has been set at a three-number combination, for
example 36-82-44, unlock it as follows:
1 If a keylock is fitted to the combination lock, insert the key into
the lock and turn it clockwise.
2 Turn the dial counterclockwise, passing the first number (36)
three times, stop on the first number (36) the FOURTH time.
3 Turn the dial clockwise, passing the second number (82) twice,
and stop on the second number (82) the THIRD time.
4 Turn the dial counterclockwise, passing the third number (44)
once, and stop on the third number (44) the SECOND time.
0
90
80
70
60
50
40
30
20
10
Changing Index
Opening Index
Dial