Motorised Card Reader
How to Remove Captured Cards from a Motorised Card Reader
10-6 NCR Personas M Series 5887 Operator Manual
6 If your ATM does not have the auto-supervisor option, press the
switch on the operator panel to the normal position.
7 Close and lock the exterior of the ATM.
Latch Fast Card Capture
10
To remove captured cards, proceed as follows:
1 Open the exterior of the ATM.
2 If your ATM does not have the auto-supervisor option, press the
switch on the operator panel to the supervisor option.
3 Access the card reader as described in ‘Getting Started’.
4 Push down the latch on the side of the card capture cradle,
which is positioned behind the card reader, and pull the card
capture container out of the cradle.
To Next Page
Loading...
