Getting Started
How to Enter Supervisor Mode
NCR Personas M Series 5887 Operator Manual 1-7
How to Enter Supervisor Mode
1
Auto-Supervisor
1
If your ATM is fitted with the auto-supervisor facility, opening the
top-box or the security enclosure of your ATM will automatically
enter the ATM into Supervisor Mode. From Supervisor Mode,
follow your in-house procedures for device status information (see
Chapter 3, "Error Reporting"). When you close your ATM it will
automatically return to the Normal Mode.
If you want to return the ATM to Normal Mode whilst keeping the
exterior of the ATM open, pull out the button shown in the
following illustration.
Supervisor Mode
1
If your ATM is not fitted with the auto-supervisor facility, your
ATM will continue to run your application when the exterior of the
ATM is open. In this case you must use the switch on the operator
panel to manually enter your ATM into Supervisor Mode.
If you do not have the auto-supervisor option, then you will have to
enter the Supervisor Mode manually.
1 Open the top-box of your ATM.
To Next Page
Loading...
