NCR 5887 - Locking the Master Lock

Getting Started
How to Unlock and Lock a Controlled Access Electronic Lock
NCR Personas M Series 5887 Operator Manual 1-23
10 Hold the PI key against the key reader to verify a valid user
identity. If sub-lock access is required, the appropriate authority
is passed to the PI key at this stage.
11 If the correct 6-digit code has been entered and a valid PI key
has been pressed against the key reader, OPr will be displayed
on the LCD.
Note: If an incorrect code or PI key is used or there is a bad PI
key contact, a lightning bolt symbol will be displayed on the
LCD, indicating an error condition.
If the error condition was caused by a bad PI key contact, YOU
HAVE ONE MORE ATTEMPT AT OPENING THE LOCK. If the
error condition occurs after the 2nd attempt, contact the KMC
immediately.
12 Turn the lock dial a quarter turn (90
o
) clockwise to release the
bolt.
13 Open the security enclosure.
Locking the Master Lock
1
To lock the master lock, proceed as follows:
1 Close the security enclosure.
2
3
4
5
1
*
6
#
7
8
9
0
LCD
Keypad
Dial
(Opening/Closing)
Key Reader
PI Key